Home › Forums › Truck Camper Adventure Forum › Fabricate a bumper for a Northstar Laredo
- This topic has 1 reply, 1 voice, and was last updated 4 years, 9 months ago by
ardvark.
- AuthorPosts
- February 23, 2019 at 18:22 #29431
ardvark
ParticipantI like the 4″ square bumper on our Hallmark and would like to do something similar on our new Laredo. Since our truck is a long bed, it has the detachable wrap so I can’t simply use the NorthStar bumper available with the permanent wrap on the short bed models.
Has anyone fabbed a bumper on a NorthStar or any other TC? I’m thinking about getting some 2″ square and welding up some supports that will fit into the receiver for the hitch. Other ideas?
Steve and Andra
2012 F350 6.2 gasser SRW LB
Fab Fours front and rear in case we run into a rhino
2019 Northstar Laredo SC - February 24, 2019 at 06:31 #29435
ardvark
ParticipantHow about this. Torklift makes a rear bumper for their short bed model with the permanent wrap. If you have this model with a bumper, can you advise me why it can not be used on a detachable wrap model? It must have to do with support, but is there no way to reinforce the rear on the long bed model? I’m going to call the factory on Monday and ask that question, but thought someone here might know.
Steve and Andra
2012 F350 6.2 gasser SRW LB
Fab Fours front and rear in case we run into a rhino
2019 Northstar Laredo SC
- AuthorPosts
- You must be logged in to reply to this topic.