Harvey,
I just went out and looked at mine. It looks to me like your nozzle is not pulled out far enough and is pointed up a little. Mine is pulled out far enough so there is a short flat area on the nozzle behind the taper which shows on your picture. It think this is just an adjustment issue with the nozzle where the water comes out. I do not think it is a malfunction or an issue of too much pressure. At least that is my take on the situation.
Steve
Steve and Andra
2012 F350 6.2 gasser SRW LB
Fab Fours front and rear in case we run into a rhino
2019 Northstar Laredo SC
